Rigid boxes / JETDIELINE

Neck box – base wrap

Wrapping paper for the neck box base: cross shape with corner flaps and turn-ins over the top edge inwards.

Neck box – base wrap — Dieline preview of the documented example. Set the dimensions and production material in JetDieline.

Interactive 3D fold view

03 / BOX

Simplified display model without material thickness, not to scale.

Template ID: rigid.neck.base.wrap
Component: Rigid boxes
Current template version: V1
Dieline preview version: V1

This template is a component of a packaging assembly. Match its dimensions to the other parts; lids, bases, wraps and linings serve different purposes.

How it is assembled

Apply adhesive across the entire wrap and position the shell centrally. Fold up front and rear walls, fold corner flaps around the edges, glue end walls over them and fold turn-ins inwards.

Material and grain direction

Grain direction of greyboard and wrapping paper parallel to the blank's x-axis: the long grooves fold cleanly, and board and paper do not warp against each other during lamination (check with the box manufacturer).

Test fit, folding and closure on a sample made from the intended material. Confirm material thickness, grain direction and production steps with your printer.

Bottles need correctly sized openings, separation and secure carrying. Compare carriers, dividers and rigid gift packaging. Test the full construction with filled bottles.

Dimensions of the illustrated example

150 × 100 × 60 mm

15 × 10 × 6 cm5.91 × 3.94 × 2.36 in / ″

Length: 150 mmWidth: 100 mmHeight: 60 mm

Inside dimension

These dimensions describe the preview, not a fixed packaging size. The app recalculates the dieline for your own dimensions.

What to consider for this construction

Greyboard thickness

Thickness of the greyboard around which the wrap is folded; the assembly sets it from the greyboard material.

Turn-in

Depth to which the wrap is turned inwards over the top edge, measured from the inside edge.

Corner tab

Width of the tabs that wrap around the vertical edges and are covered by the neighbouring wall's wrap.

Frequently asked questions

Why is the neck strip 80 mm high?

The 20 mm neck height describes the protrusion above the base, not the entire strip height. With a base inside height of 60 mm, this produces an 80 mm neck strip. It reaches down to the base and is glued to its inside walls. Check actual seating after wrapping; adhesive application and turn-ins can affect support.

How does this lid differ from a telescopic lid?

The neck box lid fits over the wrapped neck and rests on the base. It therefore does not need to fit over the entire base outside dimension. The model derives its inside dimensions from the base inside dimension and clearance. A lid from the lid and base box uses a different relationship and cannot be adopted unchanged.

Why is the neck cross-section smaller than the base interior?

The base contains wrapping paper, and the neck is also wrapped. The model therefore subtracts four paper thicknesses from the base inside dimension before determining the neck's outside cross-section. Two board thicknesses are also subtracted for the neck interior. With different paper, the whole assembly must be recalculated; check installation with the actual wrapped parts.