Envelopes and cards / JETDIELINE

Gift card holder

Folded card or single card with four corner slots (corner pockets) or two side slots for a gift card in credit card format 85.6 × 54 mm; optional header with hanging hole.

Gifts Retail

Gift card holder — Dieline preview of the documented example. Set the dimensions and production material in JetDieline.

Interactive 3D fold view

03 / BOX

Simplified display model without material thickness, not to scale.

Template ID: card.giftholder
Construction: Envelopes and cards
Current template version: V1
Dieline preview version: V1

How the shape is constructed

The holder starts as a folded card with a gift card on the inside of the back. Four corner slots hold its corners. Two side slots are provided as an alternative. The holder can remain a single card or have an additional header with a hanging hole.

How it is assembled

Slide the gift card's corners into the corner slots or its sides into the side slots. Close the folded card at the fold.

Material and grain direction

Grain direction vertical on the blank (check)

Test fit, folding and closure on a sample made from the intended material. Confirm material thickness, grain direction and production steps with your printer.

Dimensions of the illustrated example

105 × 148 mm

10.5 × 14.8 cm4.13 × 5.83 in / ″

Width: 105 mmHeight: 148 mm

Outside dimension

These dimensions describe the preview, not a fixed packaging size. The app recalculates the dieline for your own dimensions.

What to consider for this construction

Card width

Width of the inserted card (credit card 85.6 mm).

Card height

Height of the inserted card (credit card 54 mm).

Clearance

Allowance per side between card and slots.

Mounting

Four diagonal corner slots that engage the card corners, or two vertical slots at the card's side edges.

Card position

Card centre as a proportion of the height, measured from below.

Frequently asked questions

Which dimensions belong to the card and which to the holder?

The size 105 × 148 mm describes the holder's finished format. giftCardWidth and giftCardHeight describe the inserted card; their starting values are 85.6 × 54 mm. Do not interchange these two sets of dimensions. Also check the set clearance and position on the holder's back.

Are the corner pockets glued-on parts?

No. The corners option creates four corner slots in the card holder. The card corners slide into them. No separate glued-on pockets are calculated. Check insertion direction on the sample and whether the card corners are held securely without the board tearing at the slot ends.

Can I use two side slots instead of corner slots?

Yes. giftCardMount offers corners and slits. slits uses two side slots for mounting. Slot position follows the entered card size and clearance. After switching, assembly and artwork must be checked again; identical holder outside dimensions do not mean that both mounting methods behave the same way.