Rigid boxes / JETDIELINE

Drawer box – tray wrap

Wrapping paper for the tray: cross with corner flaps and turn-ins, optionally with a slot above the tray's slot.

Drawer box – tray wrap — Dieline preview of the documented example. Set the dimensions and production material in JetDieline.

Interactive 3D fold view

03 / BOX

Simplified display model without material thickness, not to scale.

Template ID: rigid.drawer.tray.wrap
Component: Rigid boxes
Current template version: V1
Dieline preview version: V1

This template is a component of a packaging assembly. Match its dimensions to the other parts; lids, bases, wraps and linings serve different purposes.

How it is assembled

Apply glue across the whole wrap and centre the drawer on it. Fold up front and back walls, fold corner flaps around the edges, glue end walls over them and fold turn-ins inwards.

Material and grain direction

Grain direction of greyboard and wrapping paper parallel to the blank's x-axis: the long grooves fold cleanly, and board and paper do not warp against each other during lamination (check with the box manufacturer).

Test fit, folding and closure on a sample made from the intended material. Confirm material thickness, grain direction and production steps with your printer.

Compare opening and presentation: pillow shapes, bands, drawers or lift-off lids. Plan the fit of contents and inserts and allow clearance between moving parts.

Dimensions of the illustrated example

150 × 100 × 40 mm

15 × 10 × 4 cm5.91 × 3.94 × 1.57 in / ″

Length: 150 mmWidth: 100 mmHeight: 40 mm

Inside dimension

These dimensions describe the preview, not a fixed packaging size. The app recalculates the dieline for your own dimensions.

What to consider for this construction

Greyboard thickness

Thickness of the greyboard around which the wrap is folded; the assembly sets it from the greyboard material.

Turn-in

Depth to which the wrap is turned inwards over the top edge, measured from the inside edge.

Corner tab

Width of the tabs that wrap around the vertical edges and are covered by the neighbouring wall's wrap.

Ribbon handle

Slot in the right end wall of the tray and wrap, through which a ribbon handle is threaded and glued on the inside.

Ribbon handle width

Width of the ribbon handle; the slot is 2 mm longer and 3 mm wide.

Frequently asked questions

Which dimensions does the sleeve table describe?

The sleeve uses starting values of 153 mm length, 104.6 mm inside width and 43.1 mm inside height. These dimensions are derived from the greyboard tray, starting clearance and paper. They are not additional product dimensions. When changing the tray interior, sleeve and both wraps must be recalculated together.

Why is the pull ribbon in two blanks?

The oblong hole lies in the greyboard tray’s right end wall. With the pull ribbon enabled, the tray wrap receives a matching oblong hole over this opening. Both parts must use the same setting and ribbon width. The starting preview shows the ribbon disabled; actual ribbon assembly requires a recalculated variant and an assembly test sample.

How wide can the pull ribbon be?

The ribbonWidth parameter allows 6 to 25 mm and starts at 10 mm. The oblong hole and its bridges must also fit within the end wall. The contour is 2 mm longer than the ribbon width and 3 mm wide; at least a 5 mm bridge remains on each side. The geometric limit may be tighter than the parameter range.