Rigid boxes / JETDIELINE

Drawer box – tray wrap

Wrapping paper for the tray: cross-shaped blank with corner flaps and turn-ins, optionally with a slot over the tray's slot.

Drawer box – tray wrap — Dieline preview of the documented example. Set the dimensions and production material in JetDieline.

Interactive 3D fold view

03 / BOX

Simplified display model without material thickness, not to scale.

Template ID: rigid.drawer.tray.wrap
Component: Rigid boxes
Current template version: V1
Dieline preview version: V1

This template is a component of a packaging assembly. Match its dimensions to the other parts; lids, bases, wraps and linings serve different purposes.

How it is assembled

Apply glue over the entire wrap and center the tray on it. Fold up front and back walls, fold corner flaps around the edges, glue end walls over them, and fold turn-ins inward.

Material and grain direction

Grain direction of greyboard and wrapping paper parallel to the x-axis of the blank: the long grooves fold cleanly, and board and paper do not warp against each other during wrapping (check with the rigid box manufacturer).

Test fit, folding and closure on a sample made from the intended material. Confirm material thickness, grain direction and production steps with your printer.

Compare opening and presentation: pillow shapes, bands, drawers or lift-off lids. Plan the fit of contents and inserts and allow clearance between moving parts.

Dimensions of the illustrated example

150 × 100 × 40 mm

15 × 10 × 4 cm5.91 × 3.94 × 1.57 in / ″

Length: 150 mmWidth: 100 mmHeight: 40 mm

Inside dimension

These dimensions describe the preview, not a fixed packaging size. The app recalculates the dieline for your own dimensions.

What to consider for this construction

Greyboard thickness

Thickness of the greyboard around which the wrap is folded; the assembly sets it from the greyboard material.

Turn-in

Depth to which the wrap folds inward over the top edge, measured from the inside edge.

Corner flap

Width of the flaps that wrap around the vertical edges and are covered by the adjacent wall wrap.

Pull ribbon

Slot in the right end wall of the tray and wrap, through which a pull ribbon is threaded and glued on the inside.

Pull ribbon width

Width of the pull ribbon; the slot is 2 mm longer and 3 mm wide.

Frequently asked questions

Which dimensions does the sleeve table describe?

The sleeve uses 153 mm length, 104.6 mm inside width, and 43.1 mm inside height as starting values. These dimensions are derived from the grayboard tray, starting clearance, and paper. They are not additional product dimensions. When changing the tray interior, the sleeve and both wraps must be recalculated together.

Why is the pull ribbon in two blanks?

The oblong slot lies in the grayboard tray's right end wall. With the pull ribbon enabled, the tray wrap receives a matching oblong slot over this opening. Both parts must use the same setting and pull ribbon width. The starting preview shows the pull ribbon disabled; actual ribbon assembly requires a recalculated variant and an assembly test sample.

How wide can the pull ribbon be?

The ribbonWidth parameter allows 6 to 25 mm and starts at 10 mm. The oblong slot and its bridges must also fit in the end wall. The outline is 2 mm longer than the ribbon width and 3 mm wide; at least a 5 mm bridge remains on each side. The geometric limit may be tighter than the parameter range.