Rigid boxes / JETDIELINE

Drawer box – sleeve (grayboard)

Greyboard sleeve: strip with three V-grooves, open at both ends, with a joint at the lower front edge.

Drawer box – sleeve (grayboard) — Dieline preview of the documented example. Set the dimensions and production material in JetDieline.

Interactive 3D fold view

03 / BOX

Simplified display model without material thickness, not to scale.

Template ID: rigid.drawer.sleeve
Component: Rigid boxes
Current template version: V1
Dieline preview version: V1

This template is a component of a packaging assembly. Match its dimensions to the other parts; lids, bases, wraps and linings serve different purposes.

How it is assembled

Fold front, back, and underside at the grooves until the underside meets the front. Close the butt joint with adhesive tape, then wrap.

Material and grain direction

Grain direction of greyboard and wrapping paper parallel to the x-axis of the blank: the long grooves fold cleanly, and board and paper do not warp against each other during wrapping (check with the rigid box manufacturer).

Test fit, folding and closure on a sample made from the intended material. Confirm material thickness, grain direction and production steps with your printer.

Compare opening and presentation: pillow shapes, bands, drawers or lift-off lids. Plan the fit of contents and inserts and allow clearance between moving parts.

Dimensions of the illustrated example

153 × 104.6 × 43.1 mm

15.3 × 10.46 × 4.31 cm6.02 × 4.12 × 1.7 in / ″

Length: 153 mmWidth: 104.6 mmHeight: 43.1 mm

Inside dimension

These dimensions describe the preview, not a fixed packaging size. The app recalculates the dieline for your own dimensions.

What to consider for this construction

Joint gap

The walls placed between the long walls are shorter by this value at each joint so they do not bind during erection.

Frequently asked questions

Which dimensions does the sleeve table describe?

The sleeve uses 153 mm length, 104.6 mm inside width, and 43.1 mm inside height as starting values. These dimensions are derived from the grayboard tray, starting clearance, and paper. They are not additional product dimensions. When changing the tray interior, the sleeve and both wraps must be recalculated together.

Why is the pull ribbon in two blanks?

The oblong slot lies in the grayboard tray's right end wall. With the pull ribbon enabled, the tray wrap receives a matching oblong slot over this opening. Both parts must use the same setting and pull ribbon width. The starting preview shows the pull ribbon disabled; actual ribbon assembly requires a recalculated variant and an assembly test sample.

How wide can the pull ribbon be?

The ribbonWidth parameter allows 6 to 25 mm and starts at 10 mm. The oblong slot and its bridges must also fit in the end wall. The outline is 2 mm longer than the ribbon width and 3 mm wide; at least a 5 mm bridge remains on each side. The geometric limit may be tighter than the parameter range.