Corrugated components and inserts / JETDIELINE

Half slotted container

Four walls with a glue flap and bottom flaps, open at the top: the half slotted container can serve as a shelf box or base. The own parametric construction calculates only this open box body.

Shipping Retail

Interactive 3D fold view

03 / BOX

Simplified display model without material thickness, not to scale.

Template ID: corrugated.halfslotted
Construction: Corrugated components and inserts
Current template version: V1
Dieline preview version: V1

How the shape is constructed

The wall sequence is closed into a tube using the glue flap. At the bottom, short inner flaps sit under the outer flaps; at the top, all walls end at a straight cut edge. A separate lid is not part of this template. Height denotes wall height in the chosen dimension reference.

How it is assembled

Glue or stitch the glue flap to the opposite wall and flatten the box. Erect for filling, fold in the inner bottom flaps, close the outer flaps over them, and seal with tape; the top remains open.

Material and grain direction

Grain direction parallel to height (check)

Test fit, folding and closure on a sample made from the intended material. Confirm material thickness, grain direction and production steps with your printer.

Dimensions of the illustrated example

300 × 200 × 150 mm

30 × 20 × 15 cm11.81 × 7.87 × 5.91 in / ″

Length: 300 mmWidth: 200 mmHeight: 150 mm

Inside dimension

These dimensions describe the preview, not a fixed packaging size. The app recalculates the dieline for your own dimensions.

What to consider for this construction

Glue flap

Width of the glue flap used to glue the blank into a tube. The material requires a minimum width.

Glue flap angle

Bevel at the ends of the glue flap; facilitates folding and erection.

Flap gap

Gap between neighboring flaps or walls; at least approximately the material thickness.

Frequently asked questions

Does the half slotted container have a lid?

No. The top edge remains open; top flaps are entirely absent. A separate telescoping lid must be designed to fit and checked. This template does not calculate its fit automatically. For a two-part construction calculated together, the telescope box provides a base and lid with their own assembly relationship.

How is the bottom closed?

After erection, fold in the inner flaps and close the outer flaps over them. According to the assembly description, the bottom is sealed with tape. The side seam is glued or stitched beforehand. Check closure and wall alignment on the filled sample; a valid contour does not verify a particular fill weight.

Can flapGap be zero?

The parameter range starts at 0 mm; this corresponds to a knife cut. However, the material-dependent constraint requires room for thickness at the flap corner. The parameter range alone therefore does not allow every combination. The machine minimum must also suit the chosen bottom closure.